以下情況表明變速箱需要維修

The following conditions indicate that the transmission needs repair

1.故障燈亮；現在汽車的電氣控制非常高。變速計算機可以監視部分損壞。如果找到4S店或維修店，則可以閱讀。如果問題不嚴重，則清除故障代碼。

1. The fault light is on; Now the electric control of cars is very high. The variable speed computer can monitor some damage. If you find a 4S shop or repair shop, you can read it. If the problem is not serious, clear the fault code.

2.自動變速箱發出異常聲音

2. The automatic transmission makes an abnormal sound

在AT變速箱上，會發出差速器老化的聲音，cvt無級變速箱，壓力缸很容易響鈴，雙離合變速箱，雙離合盤容易響鈴。

On at gearbox, the aging sound of differential will be sent out. CVT continuously variable transmission and pressure cylinder are easy to ring, while double clutch gearbox and double clutch disc are easy to ring.

3.變速箱不升檔；行駛中僅1檔或2檔，無3檔，超速檔，通常，發動機功率不足，應檢查并調整節氣門拉線，節氣門位置傳感器，檢查車速傳感器，檢查檔位開關信號，測量調速器油壓，調速器油壓為零后還是很低。車速增加，表明調速器有故障或漏油。如果控制器系統沒有故障，則應拆卸自動變速器并檢查離合器是否打滑。檢查離合器，制動器，閥體和活塞是否有壓縮空氣泄漏。

3. The transmission does not upshift; When driving, there is only gear 1 or gear 2, no gear 3 and overdrive. Generally, the engine power is insufficient. Check and adjust the throttle cable, throttle position sensor, vehicle speed sensor, gear switch signal, and measure the governor oil pressure. After the governor oil pressure is zero, it is still very low. An increase in vehicle speed indicates that the governor is faulty or leaking oil. If there is no fault in the controller system, disassemble the automatic transmission and check whether the clutch slips. Check whether there is air leakage in the valve body, clutch and brake.

4.變速箱有異味；變速箱用油潤滑以降低溫度。如果油溫過高，某些零件會燃燒并散發出異味。這意味著變速箱的某些部分無法正常工作。自動與手動不同。如果摩擦襯片和制動襯片反復組合和分離，可能會燒壞。

4. The gearbox has peculiar smell; The transmission is lubricated with oil to reduce the temperature. If the oil temperature is too high, some parts will burn and give off peculiar smell. This means that some parts of the transmission are not working properly. Automatic is different from manual. If the friction lining and brake lining are combined and separated repeatedly, they may burn out.

不同的變速箱油具有不同的性能和不同的摩擦系數。因此，在選擇變速箱油時，車主應嘗試選擇更合適的變速箱油，這樣可以保持變速箱的良好性能并延長其使用壽命。

Different transmission oils have different properties and different friction coefficients. Therefore, when selecting the transmission oil, the owner should try to choose a more appropriate transmission oil, which can maintain the good performance of the transmission and prolong its service life.

5.變速箱跳；正常運行的變速箱應停在您指定的檔位，或由變速箱計算機預設的檔位，但有時，變速箱會直接跳至空檔，因此請當心，應及時去維修店或4s店維修。

5. Gearbox tripping; The transmission in normal operation should stop at the gear you specify or the gear preset by the transmission computer, but sometimes the transmission will jump directly to neutral. Therefore, please be careful and go to the repair shop or 4S shop in time.

6.齒輪不動；點火后，前進檔或倒檔被接合，并且車輛沒有反應。這可能是由于變速箱中嚴重的機油泄漏引起的，也可能是由于變速桿或齒輪脫落引起的。

6. The gear does not move; After ignition, forward or reverse gear is engaged and the vehicle does not respond. This may be caused by serious oil leakage in the transmission, or it may be caused by the falling off of the shift lever or gear.

以上就是為大家介紹的有關濟南自動變速箱維修?的詳細的介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以的態度,為您提供服務http://www.haoyouyuan.com.cn

The above is a detailed introduction to the maintenance of Jinan automatic transmission. I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service http://www.haoyouyuan.com.cn